interior lights on 03 police impala
Login | |
|
interior lights on 03 police impala - 8/26/2008 7:06:36 PM
|
|
|
jacintofd1
Posts: 2
Joined: 8/26/2008 Status: offline
|
Hello, could anyone offer any help on this?? I have a 2003 Impala Police Car (9C1) that I use in our local fire dept. the Interior lights only work when the head light switch is turned, they do not come on when the doors are opened (I understand this set up this way so the bad guys cant get a look inside at night as a cop gets out of the car at nite) but makes it hard to find fire fighting gear or medical supplies or just gettin in and out of the car at night for me. Ive looked for the switch that control the lights as the doors are opened but I cant find it, any ideas where the switch is? it may only be unpluged. the rear locks and inside door latches were just not hooked up but were there ready for me to attach them....
|
|
|
|
|
|
|
|
|
|
RE: interior lights on 03 police impala - 8/27/2008 4:49:05 PM
|
|
|
jacintofd1
Posts: 2
Joined: 8/26/2008 Status: offline
|
all doors cause the chim to sound when doors are opened the head lights will turn off as they should when the doors are opened. I did not know if they worked from a separate switch.... would the BCM control anything like the dome lights? or is it something that I could control thru "settings" on the radio?
|
|
|
|
|
|
RE: interior lights on 03 police impala - 8/29/2008 2:03:02 PM
|
|
|
shawnvw
Posts: 1286
Joined: 1/18/2008 Status: offline
|
You stated in a PM to me that the vehicle has a dome light disable feature. I think the dome lights will either need to have the BCM reprogrammed or is just has to be that way. Like I said,I''m not too familiar with the police package. I wil give you a work around though if you are feeling up to doing a little wiring. Not hard at all to do. You may want to get a couple 1 amp diodes from your local radio shack but not 100% neccessary. What you''ll do is send the signal from the door tirggers to the BCM to make it think you are turning on the manual switch at the headlight switch. At the BCM (above the E-Brake), there is a gray 16 pin connector. Install a diode with the gray band towards the bcm into pin A1, Dk Blu\Wht. Install another diode with gray band towards the bcm into pin A8 DkBlu wire. take the other end of the diodes, twist them together with an extension of wire, and attached it to pin B6 DkBlue wire of connector 2 which is also gray but has 24 pins. If done correctly, the dome lights will turn on when the doors are opened. If you decide to not use the diodes, the only thing that will happen is when you maunally turn on the dome lights, the door ajar light will come on. No damage will occur so if you don''t mind the light coming on, don''t bother with the diodes. Hope that helps man
_____________________________
If you have a question, ask it in the forums. I will no longer be answering questions sent to my email.
|
|
|
|
RE: interior lights on 03 police impala - 9/10/2008 11:31:44 PM
|
|
|
chankee
Posts: 9
Joined: 9/6/2008 Status: offline
|
Maybe some codes needs to be reset or some wirings need to be checked and fuses need to be replaced. Was your chevrolet impala tail light are included or the interior lights only? Because that happened to my car before, if you need to turn on one light, you need to turn everything on and turn them all off if ever.
|
|
|
|
Today's Posts
Most Active Topics
Make A Donation
Forum Rules & FAQ
RSS Feeds
Chevy Prices
Chevy Forums
Monte Carlo
Corvette
Camaro
Advertising Info
|
Contact Us |
Advertising |
Automotive Directory |
Archive |
About Us |
Link To Us |
Chevy Links |
Legal |
Privacy Policy |
© Chevrolet Forum
Chevrolet Forum .com is not affiliated with or endorsed by Chevrolet Motors Division or General Motors.
|