Brake Master cylinder question

Printable Version

Chevrolet Forums >> Chevy Cars >> Monte Carlo >> Brake Master cylinder question

Page: [1]

Login Message << Older Topic   Newer Topic >>

Brake Master cylinder question - 9/6/2006 6:12:32 PM    Ouling   Posts: 1 Joined: 9/6/2006 Status: offline I'm working on my girlfriends Monticarlo z34. The oddball is when i replace the brake master cylinder, the push rod is non adjustable. I need it to be longer. What is the best way to deal with this? try to buy a longer one, or just start adding washers in the back? And the brake doesn't start until the pedal is halfway, and it seems to have a blank spot there before it start moving the brake fluid. Very firm pedal action, but no reponse until it hit the blank spot, then it start working. It is also slower at returning to initial position. I'm pretty sure it's the pushrod is too short, but correct me if i'm wrong. THANK YOU! Post #: 1

RE: Brake Master cylinder question - 10/14/2006 4:48:20 PM    xx5150pitsxx   Posts: 8 Joined: 10/14/2006 Status: offline put in 600 washers then go buy a new rod (in reply to Ouling) Post #: 2

Today's Posts
Most Active Topics
Make A Donation
Forum Rules & FAQ
RSS Feeds

Chevy Prices

Chevy Forums
Monte Carlo
Corvette
Camaro

Top 10 Posters
zx1100f1 2429 evansblue 2331 73shark 2314 biglg 2166 engine2 1707 shawnvw 1259 tahoe07 1139 northey87 911 malibumaxxss 625 golfer 610

New Vendors
Sportwing