turkish stroker engine

Chevy Forum Chevy Classifieds Photo Gallery Chevrolet News Search Contact CF Sponsors
Member List Forum FAQ Chevy Timeslips Chevy Recalls TSBs Calendars Register Login

turkish stroker engine

Printable Version

Chevrolet >> General Chevrolet Forums >> General Tech >> turkish stroker engine

Page: [1]

Message

<< Older Topic Newer Topic >>

turkish stroker engine - 5/3/2008 12:32:05 PM

daturkishulan

Posts: 2
Joined: 4/29/2008
Status: offline

last year i bought a 1977-79 downsize caprice classic.ive a lot of american cars here.therefore that caprice has been waiting to repair since i bought it.

it has a broken(frozen during winter) 350 engine.i wanna swap it for new one but not 350 again.i decided to build a real stroker engine.

in my opinion the best choise is 327 engine with 383 or 400(3.80'' , 4.00'') crankshaft.consequently it will have a long stroke.
then the cylinder heads must be in low volume to keep the compression ratio over 12 , 13:1 ,like 64cc heads.and i need appropriate forged light in weight pistons.
by the way dont worry about knocking or slaping of the piston cause of high comp ratio.because as a mech engineer i calculated everything and i'll use high 98 octane gasoline.in turkey we use that kind of fuel and only 1 liter gasoline (approximately 1/4 gallon) is 3dollars :drunk:
anyway...

to build a 327 stroker engine i need some info about part cast numbers;
-the cast no of 327 engine block which suitable to 3.80'' or 4.00'' crank(ive found a 1972 year 327 crate engine brand new but i dont now if its suitable)
-the number of crankshaft
-which forged or light weight pistons (maybe standard) and rods
-the cast number of low volume heads
-and finally which balancer?

the high compression ratio doesnt matter in point of detonation.
i ll use high octane gasoline,ceramic coated heads,pistons and aquamist system.
fellows im waiting for your suggestions.
thanks everybody.