|
kcb37 -> RE: ENGINE STALLING (8/24/2006 8:33:32 PM)
|
Are you sure about that NCHEVYHEVN? Their are more codes for the o2 sensors than low and high voltage. WRT111 Do you know what the trouble code was? If it is your oxygen sensors doing this you may be able to let it idle until it is at normal opperating temp and it should stall. That is because the oxygen sensors don't immediately control any of your air fuel mixture, the computer uses other sensors and presets, once warmed up they will start to control the air/fuel. But if it will start and drive after a couple of minutes that dosen't seem likely. Dose it drive fine after it dies, or dose it die shortly after again?
|
|
|
|