no fuel from computer?
Login | |
|
no fuel from computer? - 3/16/2008 5:44:14 PM
|
|
|
lawdog
Posts: 2
Joined: 3/16/2008 Status: offline
|
Ok here goes. the truck is a 1994 s10 with the 4.3 tbi 4x4. we removed the engine to replace all the seals and gaskets in it. it has sat for 11months since we pulled the motor out. recently we got back at it and put the motor back in. the issue is...there is no imput to the fuel pump relay from the computer to turn the fuel pump on. if i hook a jumper into the relay, the pump runs. if i crank the engine over with the pump jumped no fuel is spraying into the throttle body. so it seems that the fuel side of the computer isnt sending signal to make the truck run. I poured some gas into the throttle body and the truck will run untill it runs out of gas. so the ign side is working. I have checked the 4 grounds on the back of the block. they are good. i just put a new oil pressure senser in it thinking maybe the old one was bad. no luck. so is there a saftey somewhere else in the system that i dont know about? I am having a hard time thinking its the computer, because the truck ran when we started this project. any input would be helpful
|
|
|
|
|
|
|
|
Today's Posts
Most Active Topics
Make A Donation
Forum Rules & FAQ
RSS Feeds
Chevy Prices
Chevy Forums
Monte Carlo
Corvette
Camaro
Advertising Info
|
Contact Us |
Advertising |
Automotive Directory |
Archive |
About Us |
Link To Us |
Chevy Links |
Legal |
Privacy Policy |
© Chevrolet Forum
Chevrolet Forum .com is not affiliated with or endorsed by Chevrolet Motors Division or General Motors.
|