|
crash63 -> '02 4x4 encoder motor (3/15/2008 1:28:36 PM)
|
Hi... awesome sight! Does anyone know how you align the cam/slot on the encoder motor the the cam/slot on the transfer case. My truck is stuck in 4 wheel low and popped a C0327 code. Chevrolet told me my encoder motor was blowing it's fuse so it needed replacing. They wanted $850 to do it... but I found a new NP8 motor for 50 bucks on ebay. Problem is the cam/slot is just a hair off. I jacked up the rear end, removed the fwd drive shaft, and put the truck in neutral, and tried to turn the cam on the transfer case but it's spongy and returns to it's original position. (Hope this doesnt' mean my case is trashed!) I saw one fellow who said I should turn the motor electrically with a few small wires on a battery. I'm an electrician so that's no problem... I just don't want to mess up this motor before I put it in. Any ideas??
Thank in advance!!
Tim
|
|
|
|
