1999 s-10 wont turn over

Chevy Forum Chevy Classifieds Photo Gallery Chevrolet News Search Contact CF Sponsors
Member List Forum FAQ Chevy Timeslips Chevy Recalls TSBs Calendars Register Login

1999 s-10 wont turn over

Printable Version

Chevrolet Forums >> Chevy Trucks, Vans & SUV's >> S-10 & Blazer >> 1999 s-10 wont turn over

Page: [1]

Message

<< Older Topic Newer Topic >>

1999 s-10 wont turn over - 2/25/2008 5:17:17 AM

larky

Posts: 4
Joined: 2/25/2008
Status: offline

my 1999 manual transmision s-10 with the 2.2L wont turn over. I drove it a mile from my moms house and parked it, then about an hour later i went to got to the store and had nothing. I have removed the starter and bench tested it, and it works fine. It almost acts like the clutch saftey swicth is not making contact, but I by passed that as well and still nothing. I also hear the relay in the relay center under the hood clicking and locking in (holding shut). anything else I should check? Hopefully you guys have heard this before and have a quick answer.

thanks for any suggestions

Matt

Post #: 1

RE: 1999 s-10 wont turn over - 2/25/2008 6:06:40 AM

EuroGoldLS

Posts: 2101
Joined: 7/12/2007
From: Princeton, NC, USA
Status: offline

I'm assuming you have power?
Possibilities: Starter solenoid. Starter relay (may click, but still could be bad.)
Have you tried to turn the crankshaft? If you can turn it, that will rule out the possibility of a dry lockup.

_____________________________

PM me for a custom sig or avatar!

Please do not PM me about forum problems!

(in reply to larky)

Post #: 2

RE: 1999 s-10 wont turn over - 2/25/2008 6:12:24 AM

dewey

Posts: 69
Joined: 12/17/2007
Status: offline

Did you try using jumper cables to start the vehicle? Does the battery have a good charge, are the battery cables clean?

Bench testing a starter that way, is not conclusive unless you put a load on it. If you turn on the headlites and turn the key to crank, how do the lites react? Can you take a voltage reading across the battery posts, with the key in the crank position, you may need a helper to turn the key. The reading shouldn't drop below 9 volts, that spec is subjective.

(in reply to larky)

Post #: 3

RE: 1999 s-10 wont turn over - 2/25/2008 8:32:34 AM

larky

Posts: 4
Joined: 2/25/2008
Status: offline

guys, thanks for your replies. I will check your suggestions and report back

thanks
Matt

(in reply to larky)

Post #: 4

RE: 1999 s-10 wont turn over - 2/25/2008 9:08:08 AM

sweethoneybee

Posts: 3
Joined: 2/8/2008
Status: offline

I'm no mechanic, just a Chevy truck girl, but I had a similar problem last year. My Barney is a 95 S-10 4 cylinder manual shift. I was just leaving my last class for home at the beginning of spring break when I had a no start condition. Nothing electrical worked (headlights, radio, etc.) and the starter did not engage.

I had recently had a mechanic install a new Jasper engine, and the starter was also new.
I had it towed to my mechanic, and it turned out to be the ignition switch. He put in a new switch and Barney was running like new again. There were about 150,000 miles on the truck and just a few thousand on the new parts. The ignition switch was a little sticky just before this happened (I had to jiggle the key to get it out).

Good luck, I hope this helps.

mm

(in reply to larky)

Post #: 5

RE: 1999 s-10 wont turn over - 2/25/2008 10:31:11 AM

larky

Posts: 4
Joined: 2/25/2008
Status: offline

sweethoneybee, the ignition switch was one of my fears, but turned out to be something different.

I will tell you guys what i found. I checked everything that was suggested, no results. so I hooked up the battery cables again and put my multimeter on the wires leading to the starter. the heavy guage wire had a constant 12 volts. so I hooked my meter up to the solenoid wire and had 12 volts when the key was turned to start position. then i decided to re-bench test the starter and this time it did nothing. I have not yet put a new starter in. have to wait for a ride into town. but I'm pretty sure thats it. thanks again to all that replied

Matt

(in reply to sweethoneybee)

Post #: 6