help!

Printable Version

Chevrolet Forum >> Chevy Trucks, Vans & SUV's >> Silverado >> help!

Page: [1]

Login Message << Older Topic   Newer Topic >>

help! - 2/5/2008 5:57:10 PM    crookedpanels   Posts: 1 Joined: 2/5/2008 Status: offline Alright guys/girls here is the story. I have a 1997 2500 with a 5.7 vortec for a plow truck. Drove it to the store shut it down, came out and no start, hard crank, kick back, and starter grinding occured. I replaced the starter and cleaned the crank posistion sensor. It started and ran fine, then i parked cause i didnt need it. I started it one other time and it started fine. went to start it the other day and the same symptoms as before occured. I replaced the crank posistion sensor this time with no difference. Now i am at a loss, any ideas? Thanks in advance. T Post #: 1

RE: help! - 11/26/2008 11:33:51 AM    woody_texas   Posts: 4 Joined: 11/26/2008 Status: offline check timing make certain destributor is tight (in reply to crookedpanels) Post #: 2

RE: help! - 11/27/2008 1:35:44 PM    rivereye   Posts: 121 Joined: 5/23/2008 Status: offline Assuming your system has a distributor, also make sure the rotor is  in good shape and tightly attached.   (in reply to woody_texas) Post #: 3

Today's Posts
Most Active Topics
Make A Donation
Forum Rules & FAQ
RSS Feeds

Chevy Prices

Chevy Forums
Monte Carlo
Corvette
Camaro

Top 10 Posters
zx1100f1 2429 evansblue 2379 73shark 2326 biglg 2166 engine2 1707 shawnvw 1288 tahoe07 1139 northey87 935 malibumaxxss 629 golfer 610

New Vendors
Sportwing