rocker arm torque specs

Chevy Forum Chevy Classifieds Photo Gallery Chevrolet News Search Contact CF Sponsors
Member List Forum FAQ Chevy Timeslips Chevy Recalls TSBs Calendars Register Login

rocker arm torque specs

Printable Version

Chevrolet >> Chevy Cars >> Impala >> rocker arm torque specs

Page: [1]

Message

<< Older Topic Newer Topic >>

rocker arm torque specs - 1/27/2008 1:33:19 PM

basicbob101

Posts: 2
Joined: 1/27/2008
Status: offline

Hi, new to forum;

I am replacing the upper and lower intake gaskets on my 02 Impala, 3.4 L V-6 and got it all apart before realizing that I will have to remove push rods and re-torgue rocker arms on re-assembly. I need the torque specs on the rocker arms so that I can put it back together right, library closed today so this is my only option at present to get it back together and running to go to work tomorrow. thanxz, appreciate any response. bob

_____________________________

basicbob

Post #: 1

RE: rocker arm torque specs - 1/28/2008 3:50:05 PM

basicbob101

Posts: 2
Joined: 1/27/2008
Status: offline

OK,
not finding much help here or at the library. Found Chilton's 2004 GM manual but it has two different torque specs for the rocker arms:

Under REMOVAL & INSTALLATION OF ROCKER ARMS: item 4 states on reassembly to tighten the rocker arm bolts to 14 ft lbs (19Nm) plus 30 degrees.

Under removal and replacng intake manifold gasket item 6 on reinstall says to torque the rocker arm bolts to 89 inch lbs (10Nm) plus 30 degrees.

Does 14 ft lbs equal 89 inch lbs? if so why are the Nm numbers different?
any help out there?

(in reply to basicbob101)

Post #: 2