How to program keyless remote

Printable Version

Chevrolet Forums >> General Chevrolet Forums >> General Tech >> How to program keyless remote

Page: [1]

Login Message << Older Topic   Newer Topic >>

How to program keyless remote - 12/1/2007 4:17:59 PM    Stacey   Posts: 2 Joined: 12/1/2007 Status: offline Hi all!  I'm new here and couldn't find any info on programing a remote for a 2002 Chevy Suburban....I have one remote that quit working, I replaced the battery but it still doesn't work.  Any ideas??  Any help would be greatly appreciated! Stacey Post #: 1

RE: How to program keyless remote - 12/2/2007 8:02:54 PM    John86   Posts: 254 Joined: 2/16/2007 Status: offline Transmitter Programming Procedure (Method 1 - No Tools Required) Close all the vehicle doors. Insert the ignition key into the ignition lock cylinder. Press and hold the door unlock switch. While holding the door lock switch in the unlock position, cycle the ignition ON, OFF, ON, OFF. Release the door unlock switch. The doors will lock and unlock to confirm the program mode. Press and hold the LOCK button and the UNLOCK button simultaneously on one transmitter. After a delay of approximately 15 seconds, the doors will lock and unlock to confirm the programming of that transmitter. Repeat the previous step to program up to four transmitters. Turn the ignition switch to the RUN position in order to exit the keyless entry transmitter mode. Operate the transmitter functions in order to verify correct system operation. (in reply to Stacey) Post #: 2

RE: How to program keyless remote - 12/2/2007 8:22:35 PM    Stacey   Posts: 2 Joined: 12/1/2007 Status: offline Thank you!!!!!!!! (in reply to John86) Post #: 3

Today's Posts
Most Active Topics
Make A Donation
Forum Rules & FAQ
RSS Feeds

Chevy Prices

Chevy Forums
Monte Carlo
Corvette
Camaro

Top 10 Posters
zx1100f1 2429 73shark 2269 evansblue 2194 biglg 2166 engine2 1707 tahoe07 1139 shawnvw 1097 northey87 874 golfer 610 malibumaxxss 598

New Vendors
Sportwing