How to program keyless remote (Full Version)

Chevrolet Forums >> General Chevrolet Forums >> General Tech

How to program keyless remote

  

Stacey -> How to program keyless remote (12/1/2007 4:17:59 PM)

Hi all!  I'm new here and couldn't find any info on programing a remote for a 2002 Chevy Suburban....I have one remote that quit working, I replaced the battery but it still doesn't work.  Any ideas??  Any help would be greatly appreciated!

Stacey

  
John86 -> RE: How to program keyless remote (12/2/2007 8:02:54 PM)

Transmitter Programming Procedure (Method 1 - No Tools Required)
    Close all the vehicle doors.
    Insert the ignition key into the ignition lock cylinder.
    Press and hold the door unlock switch.
    While holding the door lock switch in the unlock position, cycle the ignition ON, OFF, ON, OFF.
    Release the door unlock switch. The doors will lock and unlock to confirm the program mode.
    Press and hold the LOCK button and the UNLOCK button simultaneously on one transmitter. After a delay of approximately 15 seconds, the doors will lock and unlock to confirm the programming of that transmitter.
    Repeat the previous step to program up to four transmitters.
    Turn the ignition switch to the RUN position in order to exit the keyless entry transmitter mode.
    Operate the transmitter functions in order to verify correct system operation.

Stacey -> RE: How to program keyless remote (12/2/2007 8:22:35 PM)

Thank you!!!!!!!!

  

Page: [1]

Return to Chevrolet Forum home page or view the Full Version of this page.