95 S10 4.3 Computer Questions

Chevy Forum Chevy Classifieds Photo Gallery Chevrolet News Search Contact CF Sponsors
Member List Forum FAQ Chevy Timeslips Chevy Recalls TSBs Calendars Register Login

95 S10 4.3 Computer Questions

Printable Version

Chevrolet >> Chevy Trucks, Vans & SUV's >> S-10 & Blazer >> 95 S10 4.3 Computer Questions

Page: [1]

Message

<< Older Topic Newer Topic >>

95 S10 4.3 Computer Questions - 11/25/2007 6:57:40 PM

aj_wicked13

Posts: 29
Joined: 11/25/2007
Status: offline

I have a 95 S10 (TBI) and i believe the computer is bad... the engine is not anywere near as powerful as it was. It feels almost as if the engine isn't controlling the timing as it should. the Computer is SN 16230703 Are there anyways to test this thing without taking it to the dealer? When i put it on a OBDII Scan tool it says "cannont associate with ECM." The check engine light is not on nor has it ever been even after 143K miles. I did have to replace the Intake manifold gasket at about 120K. but i set the timing back right were it was at 0deg at idle as the decal under the hood said.

Part 2. I will doing a fair bit of towing, and was wondering if i can put a mild cam in this engine and still use the stock computer and EFI setup. (can the computer compensate enough) I know my milage is going to go down, but I would prefer to keep EFI as this is my everyday driver.

Post #: 1

RE: 95 S10 4.3 Computer Questions - 11/26/2007 7:33:01 AM

EvansBlue

Posts: 2373
Joined: 7/12/2007
From: Princeton, NC, USA
Status: offline

Make sure the wiring harness is in good shape and the connector is clean and everthing and we'll go from there.

_____________________________

2000 Blazer LS
1981 Z28 Camaro
1994 Toyota truck