Temperature sender

Printable Version

Chevrolet Forum >> Chevy Trucks, Vans & SUV's >> S-10 & Blazer >> Temperature sender

Page: [1]

Login Message << Older Topic   Newer Topic >>

Temperature sender - 10/25/2007 9:48:43 AM    staubrj561   Posts: 1 Joined: 10/25/2007 Status: offline 1994 Chevy s-10, V6 4cu. temp sender on left side of block viewing from front. Original Issue: temp gauge maxed out. Turned engine off and cooled - still maxed when turning ignition on. Chevy dealer provided a replacement sender. Was not same one-wire connector. They provided a compatible connector. Problem: Temp Gauge at zero when ignition off, moves 1/8 inch when on. Never changes position. When thermostat release water flow and sender senses temp change the CHECK ENGINE light comes on indicating sender is functional. Suggests a mismatch in sender resistance. Dealer says that's all they can provide. Question: How can I modify the resistance to match the gauge movement scale? _____________________________ RonJ Post #: 1

RE: Temperature sender - 11/3/2007 6:04:00 AM    sickvortech1   Posts: 90 Joined: 9/16/2007 Status: offline Howdy, staubrj561. A local parts store should have the matching sender unit. (in reply to staubrj561) Post #: 2

Today's Posts
Most Active Topics
Make A Donation
Forum Rules & FAQ
RSS Feeds

Chevy Prices

Chevy Forums
Monte Carlo
Corvette
Camaro

Top 10 Posters
zx1100f1 2429 73shark 2197 biglg 2166 eurogoldls 2082 engine2 1707 tahoe07 1139 shawnvw 937 northey87 863 golfer 610 malibumaxxss 598

New Vendors
K&N Engineering, Inc.