4 Door Door Assembly

Chevy Forum Chevy Classifieds Photo Gallery Chevrolet News Search Contact CF Sponsors
Member List Forum FAQ Chevy Timeslips Chevy Recalls TSBs Calendars Register Login

4 Door Door Assembly

Printable Version

Chevrolet >> Past Vehicles >> Caprice >> 4 Door Door Assembly

Page: [1]

Message

<< Older Topic Newer Topic >>

4 Door Door Assembly - 7/1/2006 4:08:42 PM

83_Caprice_Classic

Posts: 8
Joined: 7/1/2006
Status: offline

I was taking my door apart because the exterior door handle was broken so i went to replace it and everything was going good untill I tryed closing the door. The outside is alltogether, all the rods where connected and where on good. It was late so I didn't finish putting the interior panel on and the next morning I go to open the door and it won't open? I tried fromt he inside and it wouldn't open either. I finally get in the car and start trying to pull the handle to open it. It finally goes but I think something broke inside the door? The inside feels like there is nothing connecting to it. I rip away all the foam insulation and see there isn't anyting connectiong it where it acually would open the door. The outside doesn't work still. Does anybody know what I can do to atleast get one of them to work. Any pictures would help maybe.

thanks

Post #: 1

RE: 4 Door Door Assembly - 7/6/2006 11:13:25 AM

Nomad76lj

Posts: 519
Joined: 4/21/2006
Status: offline

i would take off the oposite door panal to look at that one and compare it to the broken one see if all the parts are there. and also to see where all the rods go to open the doors.

_____________________________

if every thing is under control your driving to slow
99 chevy bazer 196 000kms 4.3 v6
02 chevy malibu 65 000kms 3.1 v6
87 chevy 1/2 ton 245 000 kms 305 v8
91 toyota corola 327 000 kms new dirt car!

(in reply to 83_Caprice_Classic)

Post #: 2

RE: 4 Door Door Assembly - 7/19/2006 11:32:16 PM

83_Caprice_Classic

Posts: 8
Joined: 7/1/2006
Status: offline

I got it all figured out. The rod that pushed the lever was to short with the new handle so I had to take it out rebend it and all. The inside handle wasn't working due to the lever that pushed the opening lever got all bend and turned out of place. Just a little rebending and got it all to work.

(in reply to Nomad76lj)

Post #: 3