DTC P0135 O2 Sensor malfunction code (Full Version)

Chevrolet >> Chevy Trucks, Vans & SUV's >> Suburban

DTC P0135 O2 Sensor malfunction code

  

Suburbman -> DTC P0135 O2 Sensor malfunction code (8/23/2007 8:01:28 AM)

Our 2003 Suburban with the 5.3L is showing this code. Anyone have any particular experience or knowledge related to this sensor? Would you happen to have a general location drawing showing the placement of this sensor?
Thanks much.

  
ZX1100F1 -> RE: DTC P0135 O2 Sensor malfunction code (8/23/2007 9:28:34 AM)

This DTC indicates that there is a failure in the heater portion of the heated oxygen sensor (HO2S) the heated element has most likely burned out and is drawing less then a quarter of an amp.

Before replacing a sensor check for any open fuse.

There are two HO2 Sensors bank-1 sensor is just aft of the catalytic converter on the driver side exhaust y-pipe and bank 2 sensor is aft of the catalytic converter on the passenger side.


Without a scan tool it is tricky to determine which sensor is faulty, the best course of action may be to replace both.

Suburbman -> RE: DTC P0135 O2 Sensor malfunction code (8/23/2007 10:20:55 AM)

Thanks ZX...

I have a borrowed scan tool and it says that this is the O2 sensor heater circuit malfunction on bank 1 sensor 1... another post I found elsewhere indicates that this would be on the driver's side, ahead of the converter. ..
I haven't received my shop manuals yet....would you happen to know where this fuse is located?

Thanks again.

ZX1100F1 -> RE: DTC P0135 O2 Sensor malfunction code (8/23/2007 1:43:01 PM)

My bad, last time I try to go by memory.
Bank 1 sensor 1 is just ahead of the cat on the driver side.

Fuse is location O2A in the underhood fuse box (15-amp).

chelle26 -> RE: DTC P0135 O2 Sensor malfunction code (8/24/2007 12:55:25 AM)

try to check this one..
- - > http://www.bobblick.com/techref/projects/o2sensor/o2sensor.html
the chevy oxygen sensor is part of the emissions control system. its goal is to help the engine run as efficiently as possible and also to produce as few emissions as possible..it is positioned in the exhaust pipe and can detect rich and lean mixtures and when the oxygen sensor fails, the computer can no longer sense the air/fuel ratio, so it ends up guessing so your car performs poorly and uses more fuel than it needs to.

Suburbman -> RE: DTC P0135 O2 Sensor malfunction code (8/27/2007 5:09:41 AM)

Thanks for the input guys...replaced the O2 sensor this weekend and drove the vehicle several times and no MIL..so apparently that took care of it....

The most difficult part of the replacement is trying to get your hands up and onto the connector....the assembly line kinda builds around things sometimes...and this was one of them...laying on the garage floor underneath with a driveshaft in your way kinda hinders things....BUT it can be done.

Thanks to ZX for the fuse check location...it was good.

  

Page: [1]

Return to Chevrolet Forum home page or view the Full Version of this page.