camshaft position sensor

Printable Version

Chevrolet Forums >> General Chevrolet Forums >> General Tech >> camshaft position sensor

Page: [1]

Login Message << Older Topic   Newer Topic >>

camshaft position sensor - 7/10/2007 11:23:39 AM    boydbl   Posts: 2 Joined: 7/10/2007 Status: offline I have a 2001 chevy tracker automatic with the 2.0 engine. I had the car checked out at a local shop and was told that the camshaft position sensor was bad. I called around and found one at autozone for 76.00. I purcashed it and brought it home to put it on. I took the old one off and installed the new one, now the car wont start at all. I then took the new one off and reinstalled the old one and the car started. The car wont run but approx. 30 minutes before it starts to sputter and stall and then will not start back up until I let it sit for a while. Is there a special way to install a new camshaft sensor or is there something else wrong with the car. Does it anything to do with the timing and if so how do I install the new one. The code that I am getting from the service center is P0304 Camshaft position sensor. Thanks Brian < Message edited by boydbl -- 7/10/2007 11:26:35 AM > Post #: 1

RE: camshaft position sensor - 7/10/2007 2:07:43 PM    golfer   Posts: 610 Joined: 10/8/2006 Status: offline Scroll down the forum for the Tracker section. There is a thread describing the problem with the sensor. (in reply to boydbl) Post #: 2

RE: camshaft position sensor - 7/10/2007 2:59:09 PM    boydbl   Posts: 2 Joined: 7/10/2007 Status: offline Found it thanks (in reply to golfer) Post #: 3

Today's Posts
Most Active Topics
Make A Donation
Forum Rules & FAQ
RSS Feeds

Chevy Prices

Chevy Forums
Monte Carlo
Corvette
Camaro

Top 10 Posters
zx1100f1 2429 73shark 2206 biglg 2166 eurogoldls 2101 engine2 1707 tahoe07 1139 shawnvw 983 northey87 866 golfer 610 malibumaxxss 598

New Vendors
K&N Engineering, Inc.