|
berettaspeed15 -> RE: Slave Cylinder (12/28/2006 12:40:13 AM)
|
yah ive change a slave cylinder, it actually isnt too hard
-first unbolt it from its frame on the tranny
-pull it out and angle it with the line going down
-theres a pin that holds the feed line onto the assembly and you have to push it through with a punch
-then pull the hose apart from the slave and watch for all the fluid coming out
-then just put the new stuff in
-the new slave cylinder should come with an o ring and new hold pin
-the o ring goes down inside the slave cylinder
|
|
|
|
