Howdy!

Chevy Forum Chevy Classifieds Photo Gallery Chevrolet News Search Contact CF Sponsors
Member List Forum FAQ Chevy Timeslips Chevy Recalls TSBs Calendars Register Login

Howdy!

Printable Version

Chevrolet >> General Chevrolet Forums >> New Member Welcome Area >> Howdy!

Page: [1]

Message

<< Older Topic Newer Topic >>

Howdy! - 2/26/2006 12:07:58 PM

tidahe

Posts: 5
Joined: 2/26/2006
Status: offline

Hi, I'm new to the formum and looking for some technical help on a custom project.

I'm putting a Chevy 4.3L V6 and 700-R4 tranny in a 1968 Opel Kadett. I'm going with a carburator and no computer. Here are my questions: Did GM produce any distributors for this motor that weren't computer controlled and used a carb rather than EFI? If so, on what year and model?
Also, I've been told that some of the GM vehicles with a 4.3 used tubular steel exhaust manifolds rather than cast. Since this is a custom application, it'll be a lot easier to cut and modify the steel style. Does anyone know for sure on what year and models these were available?

I know I can get aftermarket performance parts for this motor but since this is a low budget project, I'd like to find the parts in local salvage yards and they always want to know what year, make, and model. I haven't found any of them to be too helpfull without that information.

Any ideas/suggestions would be greatly appreciated. Thanks a ton!!!!