DarkOne
1/25/2007 8:07:20 PM
I recently have had a problem with the remote. I can lock and unlock the vehicle right after I exit, but give it about 10 min or so and I no longer can unlock or lock the vehicle. I have to put the key in and unlock it. I have done the relearn for the remotes, but I don't know if I need to have the key in the ignition on. The instructions do not indicate this part. I do hear the beep to tell me it has relearned, but when I lock to cycle out of the relearn it won't get rid of the relearn screen.....HELP!!! ZX if you know what I can do w/o taking it back to the dealer I would appreciate it, since my dealer will not be able to get to it until next week.
THANKS IN ADVANCE
ZX1100F1
1/25/2007 8:34:11 PM
Try disconnecting the battery cable for at least 20 seconds, and touch the + cable end to ground while disconnected.
If this doesn't do it then you have to take it in.
DarkOne
1/25/2007 8:44:22 PM
Thanks ZX I will try it out. Do you know why this might have happened. I went to the manual and tried to relearn worked but not when I returned to the vehicle. By the way I tried both remotes, both work but again not when get back.
ZX1100F1
1/25/2007 8:51:06 PM
The GMlan is falling asleep; it is an anomaly we see occasionally. Assimilate it to; the mouse on your keyboard dying after you have left your computer alone for a while.
DarkOne
1/25/2007 9:21:38 PM
Well I hope the alarm is not falling asleep.....needs to do it's job when I am not around to protect her.

So all I do is disconnect the + and touch the neg on the battery or somewhere on the engine? I don't want to mess anything up by touching the wrong thing.
ZX1100F1
1/25/2007 9:22:51 PM
Correct.
Just be sure that you dont leave the + connected and touch the - to it.
DarkOne
1/25/2007 9:35:07 PM
Ok so disconnect + then touch the - terminal...right? but quickly!
DarkOne
1/25/2007 11:05:31 PM