Sergio_t1
3/16/2008 2:26:24 PM
ok, im new to this forum and i would really appreciate somebodys help. I have a 07 AV with factory nav and bose, and im replacing it with a pioneer z1 i have bought the pac module that retains door chimes and onstar but im not sure what i have to do to replace the amp also, and i want to keep my rear view cam i have looked everywere but no one seems to know how to tap in to it. Can some one help me?? Thank You!!
shawnvw
3/17/2008 4:57:04 PM
If you use the right pac module, you can retain the use of the factory amp. Just connect the rca's of the pac module directly to the pre-outs of the z1.
I haven't used a factory cam in an aftermarket unit before, but i don't see why you woulnd't be able to integrate it. If you connect an rca to pin 6(pink +), and pin 7(lt blu -) of connector 4(i believe its brown) then connect the rca to the camera input of the z1 you should be golden. Check the instructions of the module, but i do belive it will give you a VSS signal and also a reverse wire to make the installation go really smooth
